|
              |
Type 300 Series
Type 300-C Series Bearing Assemblies were specially developed as an improved design for bearing assemblies used in gypsum wallboard and plywood dryers. The Type 300-C Series Bearing Assemblies allowed the installation of a split type bearing cartridge on the drive side of many conveyor ovens. Once installed on a typical board dryer, bearings could be replaced or rotated without dismantling the surrounding members such as sprockets, drive chain, bearing mounts, rolls, etc. The entire change takes just a few minutes. Reduced down time, NO tools, REDUCED labor costs! Solid bearing cartridges are also available to maintain design consistency throughout an installation. Other uses for these patented bearing assemblies include plating equipment, textile finishing equipment, both drying and dying, hot and submerged conveyors and other industrial process equipment where a self-lubricating quick change bearing assembly is required. The Choice of OEMs and Users Alike!
Special Features:
|
|
|||||||||||||||||||
[ 100 Series ] [ 100-Hinge/Split Series ] [ 118 "Big Bore" Series ] [ 200 Series ] [ 300 Series ] [ 700 Series ] [ Replacement Cartridges ] [ Plain Dryer Bearings ] [ Veneer Bearings ] [ Available Grades ] [ FAQs ] [ About Metcar ] [ Contact Metcar ] [ Home Page ] METALLIZED CARBON CORPORATION Ossining, New York 10562 914-941-3738 914-941-4050 FAX sales@metcar.com All rights reserved. Please read our Terms of Access and Use. Copyright © 2002 Metallized Carbon Corporation |
|||||||||||||||||||||